With the Baxley Edger Feed Table, heavy-duty tail take-up assembly utilize precision ways, heavy-duty tapered roller bearings, improved cylinder mounting and air cushion circuit design. This lightens the moving mass 40% while adding structural strength and eliminating all over hang to minimize deflection. In addition, the pivot has been rotated 180-degrees to allow better access and repositioned upward nearer level with the pan surface to reduce the angularly of the pan efficiency, allowing more board clearance with less pan movement.
Features
- Steel cored high density UHMW cylinder clevis pin for strength, wear and resiliency
- Fetcher rods gun drilled for internal circulated lubrications all pre-plumbed piped and self contained
- Fetcher positioners bushed with zinc alloy and finished to a clearance of less than ½ a thousandth
- Minimizes positioning mechanical inaccuracy for a long life
- Very low moving mass
- Allows high acceleration and velocities
- Fetcher actuation cylinders mounted with clamp block design providing ease of removable and replacement of either fetcher positioner pin assembly or fetcher rod
- Fetcher rod pivot design
- Improved using mounted taper roller bearing
- Minimizes slope and pre-loaded nut attachment
- Maximizes holding power
- Maintains easy-to-monitor stable connection
- Improved using mounted taper roller bearing
- Close coupled remote servo valve mounting
- Minimize shock
- Maintain response
- Individual servo valve wiring junction boxes shock mounted
- Easy troubleshooting or replacement
- Air blow-off on all photo eyes with protected mounting assemblies
- Integral lube reservoir mounted and pre-plumbed
- High-capacity, PLC-controlled, low-pressure chain oilers
- Maximize lube
- Minimize over-lube for housekeeping and environmental concerns
- Sharp-top RC80-2 chain running on replaceable hardened steel race
- Air-operated pan assemblies
- Four (4) Overhead smooth chromed pressrolls with UHMW nose cones
- Dual-stroke press roll cylinders for high speed operation plus jamb clears
- Four (4) Board positioner assemblies with linear positioning cylinders, proportional valves and pressure filters
- Valves remote mounted in accessible location on far side of table
- Simple maintenance
- Shock protection
- Valves remote mounted in accessible location on far side of table
- Heavy-duty air cylinders and valves
- Heavy-duty chain tensioner with precision ways and air over hydraulic actuation
- Automatic lubrication of chain race
